Linux Terminal Control Sequences

linux35 Linux Terminal Control Sequences
Bernard Peh asked:




Linux terminals share alot in common with their primitive ancestors such as vt100 like consoles. These early devices is capable of sending sequences that signaled events outside of the normal flow of typed characters, such as escape, tab, linefeed…etc. Linux uses CTRL key to send out these out of band signals. This article summarises many of the commonly used control sequences that are used in all Linux terminals.

CTRL-C

This is the most commonly used sequence. In the bash shell, CTRL-C will terminate any currently running process and return you to the bash prompt. For example, if you accidentally run a command that does not stop, use CTRL-C to cancel the command.

CTRL-D

Many Unix commands read their input directly from the keyboard. An example is the WC command. WC counts the number of lines, words and characters that a user types in from the keyboard. So if you tpye WC at the command prompt, the command will wait for your input till you use CTRL-D to signal the end of transmission.

CTRL-Z

CTRL-Z means to suspend a program. For example, you are working with a command and you want to stop it temporary as it is taking too long. To do that, you can use CTRL-Z. You can later restore back the command using the fg command.

CTRL-U

If you have messed up a certain command and you want to start all over, instead of using backspace, you can use CTRL-U. CTRL-U resets the current line.

CTRL-H

Instead of using the backspace key, you can use CTRL-H to function the same way. Unless the backspace key is malfunctioned or mapped wrongly, this sequence serves very little purpose.

CTRL-L

If your screen is too cluttered with unwanted information, you can clear the screen using CTRL-L.

CTRL-S

Freeze your screen. This is a good command to use if you decide to go for a coffee break and do not want any process to run till you are back.

CTRL-Q

This sequence is exactly the opposite to CTRL-S. If you have freezed the screen before, you use this command to unfreeze it.

CTRL-J

Functions the same way as the RETURN key.

CTRL-G

Makes a terminal beep sound for fun and entertainment.

Control Sequences are important to all Linux / Unix users. Some sequences are important while some are useless today. It is worth memorising the first few sequences as described in this article.

Caffeinated Content – Members-Only Content for WordPress

Related Posts

bookmark bookmark bookmark bookmark bookmark bookmark bookmark bookmark bookmark bookmark bookmark bookmark
tabs-top


No Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URL

Leave a comment